1-11/16" 2 Bolt Type E Pillow Block 19321111

• Available in shaft sizes from 1-3/16 to 7” and 35mm to 170mm
• Easy Installation and maintenance
• Supplied from factory in shaft ready condition
• Assembled adjusted and pre-lubricated in advance for immediate use
• Dimensionally interchangeable with comparable competitive Type E units
• Tapered roller bearings with double extended inner race
• Extended inner race has two locking collars
• Available with standard V-Guard nitrile and Teflon Seals or balanced Labyrinth seals
• Case hardened rollers and races
• 120 degree set screw spacing on locking collars
• Timken tapered roller bearing inserts allow for a combination of radial and thrust loads
• Excellent thrust load capacity
• Close fit oversized collars act as fingers for additional protection in dusty or damp environments Rugged housings are made in the USA of Class 30 cast iron
• Standard grease operating temperature is up to 250 F
• High temperature grease is available for up to 350 F
• Housing is available in the standard painted finish, nickel plated, epoxy, Teflon and other custom finishes
• Custom machining and design is available
• Made in the United States, USA Bearings