1" Bore Pillow Block Bearing Unit, UCP205-16 

Please check the MORE INFORMATION for all dimensions on this bearing

More Information

Dimensions
Bore: 1"
Bolt hole to bolt hole: 4.133 in. (105mm)
Overall length: 5.51 in. (140mm)
Shaft height: 1.437 in. (36.5mm)
Overall height: 2.736 in. (69.5mm)
Bolt hole: .511 in. (13mm)

 INTERCHANGE
AMI: UCP 205-16
Browning: VPS-216
Dodge: 123806
Dodge: P2B-SC-100
Fafnir: RASC-1
Fafnir: YAS-1
Link-Belt: P3-U216N
Link-Belt: P3-Y216N
NSK: USP205-16S
NTN: UCP205-100T
Peer: FHSP205-16G
RHP: NP-1
Sealmaster: NP-16

This 1" Pillow Block Bearing Unit is offered online by USA Bearings & Belts, www.usabearingsandbelts.com. We offer ball bearings at wholesale prices for consumers and OEM’s, you can buy online a UCP205-16 Pillow Block. This bearing is 1" Bore ball bearing unit found in many applications. The UCP205-16 Pillow Block housing is made of Steel. 1" Pillow Block is a high premium quality unit up to the task of your application.

A pillow block bearing (plummer block) is a mounted bearing used to provide support for a rotating shaft with the mounting surface on a parallel line with the axis of the shaft.

Selection of the appropriate bearings can be accomplished based on the shaft size and the radial and thrust load requirements. Pillow block bearings are designed to support a shaft: the mounting surface is on a parallel line with the axis of the shaft. Elongated bolt holes in the base or feet of the unit allow for some adjustment and easy mounting of the pillow block bearing.

Certain dimensions and measurements of pillow block bearings are critical to selecting the right pillow block when either the original to the equipment or as a replacement. The shaft diameter is matched with the appropriate corresponding bore dimensions of the bearing unit. If a properly sized unit matching the shaft is selected, the bearing will easily slide onto the shaft and into position, ready to be secured by the locking device. Shaft height also known as backing height is determined by measuring the distance from the base (or bottom) of the pillow block to the center of the inner ring or shaft. Lastly, the distance between the bolt hole centers is taken from the center of one elongated bolt hole to the center of the housing's other bolt hole. These dimensions are viewable when you click MORE Information. A PDF with the model chart will open for you.

Housing material for a pillow block bearing is typically made of cast iron, Stainless Steel, Thermoplastic or pressed steel. Pillow block bearings are extensively used in conveyor systems such as tube chain conveyors. Most pillow block bearings are self-lubricating.

Please click the MORE INFORMATION for all dimensions on this bearing